Published 8/2022
MP4 | Video: h264, 1280×720 | Audio: AAC, 44.1 KHz
Language: English | Size: 502.84 MB | Duration: 0h 34m
How to build and program a Dual CAN and Data Logger using the Teensy 4.0/4.1 module and the free Arduino IDE
What you’ll learn
How to build and program a Dual Controller Area Network (CAN) & a CAN datalogger Interface Module using the Teensy 4.0 & 4.1 module and the Arduino IDE.
How to start programming with a Teensy (Arduino based module)
Hands on embedded software development
Sending and receiving CAN messages using 2 of the CAN ports on the Teensy 4.0 module. This can be expanded to interface to your own CAN application.
Build a CAN data logger using the SSD card on the Teensy 4.1 module.
Requirements
Basic understanding of electronics
Ability to build basic electronic circuits
Description
In this course I’ll show the student how to build a Dual Controller Area Network (CAN) module using the Teensy 4.0 single board computer and program it with the free Arduino Integrated Development Environment (IDE). The schematic and breadboard bill of material are shown with complete construction instructions. The parts from Digikey can be bought for around $35 and the Teensy 4.0 headers require simple soldering skills or the student can purchase a completed CanWiser module.Part 1 is the Introduction where an overview of the course is presented.Part 2 is building the breadboard hardwarePart 3 is getting the software from the free Arduino Integrated Development Environment to the Teensy addon and then programming the Dual CAN breadboard with a simple checkout programPart 4 is sending and receiving CAN messages using 2 of the Teensy 4.0 onboard CAN interfaces.Part 5 on building a CAN data logger to capture CAN messages and store them in the on-board SSD card on the Teensy 4.1 is included.The completed Dual CAN Module can be used by the student to further their understanding and knowledge of the Controller Area Network. Using the Teensy modules with the Arduino IDE is a great and inexpensive way to explore embedded systems programming.
Overview
Section 1: Introduction
Lecture 1 Part 1 – Introduction
Section 2: Building a Dual Controller Area Network Module
Lecture 2 Part 2 – Building The Hardware
Lecture 3 Part 3 – Getting The Development Environment
Lecture 4 Part 4 – Sending And Receiving CAN Messages
Section 3: Building a CAN Data Logger
Lecture 5 Part 5 – Building A CAN Data Logger
Software Engineers, Electrical & Electronic Engineers, Students
Password/解压密码www.tbtos.com
转载请注明：0daytown » Dual Controller Area Network Module And Can Data Logger