Cranesong Phoenix II v2.0.0 MacOS

Crane Song推出一组TDM插件的更新版本：Phoenix II，这款磁带饱和器模拟了磁带机的独特声音特性。

曾为ATR Service公司开发Aria离散式磁带录音机的设计师Dave Hill，根据他对模拟电子设备的深入了解以及作为录音工程师几十年的经验，开发了Phoenix II这款实用、具有音乐性的插件。

Phoenix II不仅提供磁带本身产生的非线性饱和特性，还呈现了模拟磁带录音机的录制/重放电子设备和均衡曲线之间的相互关系。Phoenix II采用的HEDD技术，专门为Avid的AAX架构进行了优化。

Phoenix II有五种不同的磁带模拟特性，用Type旋钮控制选择。Brightness亮度则提供三种不同的声染色明亮度，Gold黄金是近似平坦频率响应，Sapphire是更明亮的声染色，而Opal则是更暖和的音调声染色。

Phoenix II的五种磁带风格：

• Luminescent是最中性的声音处理风格；
• Iridescent具有与Luminescent类似的磁性特性，但低频和中频更丰满；
• Radiant具有更激进的压缩曲线；
• Dark Essence更加激进，具有更宽频率范围的声染色；
• Luster在开始时更温和，但在达到最大时会变得激进。

Process控制确定Phoenix II处理过程集成到音频信号中的效果量，Input Trim输入电平旋钮确定信号进入“磁带机”的音量，插件的DSP处理与电平相关，并增添了Output Trim输出电平功能。在极少数情况下，Phoenix II的Input Trim输入电平旋钮也可以用于防止过载，并增加的音量和声染色颜色。

Team FLARE | 14 FEBRUARY 2026 | 61.9 MB

RELEASE NUMBER: FLARE-1975
Phoenix II is an update of Crane Song’s suite of TDM plug-ins designed to emulate the unique properties of a magnetic tape machine.

Phoenix II runs both NATIVE and DSP on Avid’s AAX format. Beta now available with additional AU and VST3 formats! Phoenix II uses 32 bit floating point math and has a lower noise floor than the original release.

Designer Dave Hill has crafted this software with the same attention to detail he used to create the electronics for ATR Service’s much heralded “Aria” discrete tape recorders. His intimate knowledge of analog electronics, as well as decades of experience as a recording engineer has spawned a very useful, musical suite of plug-ins. The Phoenix II process not only incorporates the nonlinear saturation characteristics created by magnetic tape itself, but also includes the interrelation of an analog tape recorder’s record/reproduce electronics and equalization curves. Phoenix II is a ground-up application derived from HEDD technology, and specifically engineered and optimized for Avid’s AAX architecture.

Phoenix II has five different tape-analog characteristics, The type is selected with a switch for easy comparison between the types, and the brightness is also selected with a switch. Gold is the position where the color is approximately flat in frequency response, with Sapphire being a brighter, and Opal being a warmer tonality. A level control determines the amount of the Phoenix II process integrated into the audio signal, and an input trim determines “how hard you hit the tape.” Because the DSP process is level dependent, the input level trim control has been improved and an output trim control has been added.

The input trim can also be used to prevent clipping in the rare cases where clipping may be a problem and bringing up the level of a track for an increased amount of color. This can be useful on material that is hitting close to or at digital zero and on material that has a low recorded level. When the input trim and output trim controls are at 0dB, (no change in gain) and no tape process is being added to the sound, the plug-in is bit accurate, meaning the output exactly matches the input.

– Does not require the iLok driver to run.

HAPPY VALENTINES DAY!

System Requirements
macOS 10.13 or newer

转载请注明：0daytown » Cranesong Phoenix II v2.0.0 MacOS